DECK FLASHER — DarkWars

BROWSER NOT SUPPORTED

The flasher needs the Web Serial API — use Google Chrome or Edge on desktop (v89+). Firefox and Safari are not supported.

STEP 1 — CONNECT

Plug the deck in over USB and click CONNECT, then pick the deck's serial device (look for Espressif USB JTAG/serial debug unit) in the browser dialog. If the chip won't sync, hold BOOT while plugging it in.

STEP 2 — REVIEW

Firmware found: · source

Board

IMAGE	ADDRESS	SIZE

Upgrade app only — keep WiFi / API-key settings (full flash resets them)

FLASHING…

Preparing…

Do not unplug the deck while flashing. If the browser asks again, re-pick the same device.

DONE — DECK IS LIVE

Your deck rebooted into the DarkSec setup portal. First-run setup:

Connect to the deck's WiFi DARKSEC_C5 (password darkseclabs).
Open http://192.168.4.1 → SYNC tab.
Enter your home WiFi, WiGLE creds, and your device API key (get it from darkseclabs.com → PROFILE).
Go wardriving, then hit DIRECT UPLOAD in the SYNC tab.